SEARCH:
"CSI Wire and Cable has been providing communication cable since 1920."
Home  About Us  Products  Contact Us  Order Status 
 
Products
 Communication Cable
 Fire Alarm Cable
 Coaxial Cable
 Special App Cable
 Plenum Cable

75 ohm coaxial cable



New resources: 75 ohm coaxial cable from http://www.lowvoltagewire.com

75 ohm coaxial cable, and long s video cable information: Extra jacks will come in handy - run extracable!Mike morris, morris@grian. I bought my siemon model s66m1-50 blocks from graybar for$6. Any thoughts on what wouldwork, or do i need to rethinkmy plans. My advice would be to replace the $173 leviton unit every 5 years if you2u] Electricians know how to do this, but theindependent telephone jocks really know how to pull a wire throughanything without disturbing the plaster, paneling, etc. Each of thesespeakers has a "double" driver (cone), one angled toward the front of theroom and the other angled toward the rear, so the sound always comesindirectly to the listener. We use high-end equipment for music (mostly classical andjazz), but are not overly compulsive about being true audiophile "snobs". You are right where you were before you installed the thing.

Note that the multi-jack wall plate manufacturers know that peoplesometimes have strange ideas and want to do strange things. You should neverrun the cable in the same holes as ac for parallel runs - keep at least someseparation, and keep parallel runs very short. For my home application, thecost would be between $3500 and $4000. Just don't try to hang a picture on one.

Externalwalls would be best from that point of view, although the insulation in thewall may make it harder to fit the speaker in. So, except for the media room and the mainspeakers in our great room, we used 16 gauge wire. These then were terminated into modular jacks (rj11/45 asneeded).

More About 75 ohm coaxial cable

Soundtrack's design, based on successful installations in numeroushouses of different scales, is to use is to use speaker switching boxes thatswitch from 4 to 8 speaker pairs off one (or two) amplifier(s) usingimpedance matching transformers, not resistive loads. The design of theseimpedance-matching boxes is claimed to result "in no power loss andmaintains the amplifier's damping factor", according to one manufacturer'sspecifications. However, i believemost of the latest changes affect the device communications protocols morethan the wiring hardware, so i have confidence i am pretty well covered. Therefore, and to protect x-10 and other devices throughoutthe house, we purchased a whole-house surge protector.

A switch may allow them to be driven eitherin-phase or out-of-phase, as desired. Being cheap, ididn't want to buy either, so here's what i did.



| 75 ohm coaxial cable | flat speaker cable | plenum cable |

75 ohm coaxial cable

2002 Copyright CSI